+ Russian version + English version

Future investments and investments in projects.

Investments in projects Investments in projects
+ Flying unit fuel free.
Project - ¹1 The information enclosed. 		+ Return to previous page project - ¹ 1


Magnetism. Searl Effect.

In 1946, Englishman John Searle made a fundamental discovery of the nature of magnetism. He found that adding a small component of alternating current (100 mA), frequency (10 mnz) during the manufacture of permanent ferrite magnets attached to them new and unexpected properties.
The first set of permanent magnets, made by the described procedure consisted of two samples, each the size of 100x10x10 mm, respectively, and the two rollers. A movie was made in the form of a cylinder (10 mm), and the second - of a few (5) ring outer diameter 20 mm. All these samples were magnetized at the same time in the manner described above.
Put together these magnets, as shown in the instructions, and they begin to interact. If the magnet A slow moved by the external influence on the direction of the corner of a magnet C, and then gently push it, the magnet A gain considerable speed, roll through the corner of 2 and will continue its movement from the left side of the magnet C, until reaches an extreme point. At that moment, when the magnet A starts moving from one angle, the magnet B suddenly starts to move, further accelerated to high speed, rolling through the corners 3 and 4, and continues to move along the right side of the magnet, while as it reaches the extreme point. After the magnets pass through the extreme positions, they will oscillate synchronously (with period of 10 ms), until you stop in their new positions.

After this, Searle decided to replace the rectangular magnet ring, placing clips on the outer circumference. According to the inventor, in such a structure is observed the same effect as before. Namely, if one roller to give a little movement, the other clips are also beginning to suddenly move in the same direction.
Master John, as he was known in his homeland, found that if the number of rollers arranged around is a specific minimum number, then they come in a separate rotation, speeding up as long as do not come in dynamic equilibrium. This minimum number depends on the geometry and material properties.
Next, the scientist has revealed the following pattern: during the rotation of the device produces an electrostatic potential difference in the radial direction between the ring and rollers. Stationary ring is positively charged, and videos - in the negative. The gaps formed by the interaction of magnets and the centrifugal force, prevent mechanical and galvanic contact between the roller and ring.
If everything described earlier to add a fixed C-shaped electromagnet, then we - ready device producing electric power 100 Wt. In 1952, Searle produced his first generator.

Its diameter was about 3 feet. The device consisted of three rings, divided into segments, with electromagnets placed on the periphery. Each ring consisted of magnetic segments, separated by spaces. Due to the high cost of the generator does not contain the required minimum of magnets, and therefore could not begin to rotate independently.
The new invention was tested in the open air and is driven by a small motor. The generator produced an unusually high electrostatic potential of the order of 1,000,000 volts, which was manifested in the form of static effects near him. The characteristic crackling and the smell of ozone confirmed this conclusion.
During testing the unexpected happened. Continuing to rotate the generator began to rise up and disconnected from the engine and soared to a height of 50 feet. Here he paused a bit, driving more and more, and then became emitting a pink glow around him. There was a so-called ionization of air at very low pressures. other interesting effect was the inadvertent inclusion of adjacent radio, which is explained electromagnetic radiation as a result of discharges. At the end of the experiment generator clocked up a fantastic rate and disappeared from view, probably, going into space.
Beginning in 1952, Searle with a group of manufactured and tested over 10 generators, the largest of which was a discoid shape and reaches 10 meters in diameter.
Articles about the work of Searle, unfortunately, never published in a scientific or technical literature, but many researchers knew the results of his discoveries and experiences.
Many have tried to explain the principle of the new generator, in particular, one of them - Professor Seiko (Japan, the National Consortium for Space Research) made the following entries:
1. "In magnetization to the DC added a small alternating current (100 ma) radio frequency (10 MHz);
2. Two. for the magnetization must be a minimum of 180 ampere-turns;
3. Three. for normal operation of all magnets in a generator must be magnetized at the same time;
4. made magnets have a tendency to temporarily change their characteristic properties in contact with others in the field of permanent magnets, but after a few minutes after the external influence is removed, the magnets restore the properties, this phenomenon can be used for control purposes;
5. Five. Searle pointed out the possibility to control the behavior of the magnetization of the generator by a single small ring with a different frequency, for example, he could make a generator that is dependent on temperature so that it operates at a temperature above a certain (50 C), but below the Curie point;
6. internal magnetic field of rollers and rings are located mainly along the axes;
7. material: ferrite or magnetic ceramics;
8. Eight. measurements made Searle showed that the ratio of the power generator to the mass of a single ring is 180 kW / tonne, depending on the effects of Earth's gravitational field. "


+ If you are interested in something, you hint us to your friends, relatives or colleagues... +